The most common complaints are:
- The pilot won’t stay lit.
- The oven won’t rise to temperature.
- The oven gets too hot.
- The oven doesn't cook evenly.
Thermo couple Problem's favorite is perhaps the foremost common. Usually, it’s the thermocouple that causes this problem. When lighting the pilot, if the thermocouple is not directly in the flame it can not get hot enough to allow it to open the safety valve. If it is directly in the flame and it won’t stay lit then the thermocouple is probably defective and needs to be replaced, Keep in mind that some safety valves have the thermocouple permanently attached so the entire valve must be replaced.
If you’ve replaced the thermocouple and attempt to light the pilot and it still will not stay lit then the safety valve is defective. Remember to check the type of safety valve you have to get the correct replacement. For correct identification, procedures check out this post - frigidaire custom imperial double oven parts
When performing on any type of gas equipment always remember to shut off the gas!
Number two is usually a thermostat problem. once you set the thermostat at a group temperature and it doesn't reach that time it's going to be one among two problems: Gas Thermostat
1. The thermostat could also be defective.
2. The thermostat could also be out of calibration. to see the calibration get a thermometer that you simply know is accurate. Put it in the oven and set the thermostat to 250º. Open the kick plate below the oven door and watch the burner flame, if it pops before the oven reaches 250º you'll be ready to calibrate it.
To calibrate a thermostat remove the knob and check to ascertain what type of thermostat you have. The thermostat is either a kind with a round disk that has two screws holding it in situ or it'll have a D shaft with a little screw in the middle of it. In either case, only turn the disc or screw a fraction of a turn at a time and no quite 1 / 4 turn either direction.
Continue to turn the disc or screw a fraction of a turn whenever you see the burner come on. If you reach that quarter of a turning point and therefore the burner doesn't come on, the thermostat is defective and must be replaced. If the burner comes back on, watch the temperature of the oven and if it gets to within 5 or 10° of the preset temperature, you're good to travel. it's going to take several tries to catch on properly calibrated. imperial industrial
If you continue to can not catch on calibrated within the temperature range, you would like to exchange the thermostat. All thermostats are preset from the factory and will not require calibration when installed. If you discover that the new thermostat does require calibrating, follow the previous instructions.
Number three is additionally a thermostat problem. Follow an equivalent procedure to calibrate as you probably did for the oven not going to temperature. Again, if you can’t catch on to calibrate, replace it and therefore the oven should heat to the correct temperature. stoves cookers replacement parts
Number four may be a common problem after a replacement thermostat has been installed. All the thermostats have a capillary with a bulb attached to the top of it. this is often the part that senses the temperature in the oven. The bulb is attached to clips inside the oven. If the bulb is not replaced in an equivalent place, i.e. it’s just stuck in the oven cavity and left hanging, then the thermostat will run “wild,” meaning the oven cooks unevenly
